This MIL standard had been revised and re-issued several times, with each issue being designated a new sequential suffix letter, which appears after the main standard number. With each revision the method number specific to this particular test may have changed, but the method itself is generally as follows:
This test method is proposed as an accelerated laboratory corrosion test simulating the effects of seacoast atmosphere on semiconductor devices.
Test specimens are placed in an enclosed chamber and exposed to a continuous indirect spray of salt water solution, which falls-out on to the specimens at a rate that deposits 0.5 to 3.0/80cm²/hour based on an average run of at least 16 hours, in a chamber temperature of +35°C +1.1°C, –1.7°C. This climate is maintained under constant steady state conditions. The test duration is either 48 hours or 96 hours.
Note that a 24hr drying period at 40°C is required at the completion of the test.
Horizontal and vertical test chambers
for salt spray, condensation humidity and cyclic corrosion tests.